Market guide
Commission the studio monitor system
Verify placement, gain, clocking, calibration, level, mounting and support before relying on itCommission the delivered pair or array in its final room and signal chain. Reconcile exact model and generation, inspect cabinets and mounts, set geometry and gain, verify every analog or digital path, then measure and save a documented baseline without treating it as a promised listening result.
Install
Place and support the exact cabinets
Use stable rated stands or manufacturer-approved mounting hardware on a suitable structure. Match acoustic axes and distances, preserve port or passive-radiator clearance, manage cables and ventilation and keep heavy lifting or overhead work within a competent installation plan.
- Handed systems need an exact layout
- Dynaudio LYD 48 and HEDD Type 20 MK2 use left and right cabinet identities. Confirm the intended tweeter or driver orientation before ordering, placing and calibrating the pair.
- Side radiators need clear space
- Focal Shape 65 has a passive radiator on each side. No rear port can help one boundary decision, but it does not remove side clearance, symmetry or room-mode requirements.
Signal
Witness gain, clocking, delay and wake behavior
Set the source and monitor sensitivity for useful headroom and low noise. Test each input, channel polarity, left-right level, digital clock, DSP delay, limiter, mute, standby and recovery from power and signal interruption.
- Digital input requires a clock plan
- The JBL 705P and HEDD Type 20 MK2 accept AES/EBU, but connector presence does not verify sample-rate support, loop behavior, clock stability or the downstream control system.
- Quiet rooms expose the gain chain
- Evaluate hiss, hum, ground paths and standby at the actual listening distance. Owner reports identify tests to run, not population noise or defect rates.
Handoff
Store the baseline and service boundary
Record serials, placement, angles, distances, input trims, digital settings, calibration files, firmware, software and microphone versions, reference level, support contacts and a repeatable recheck process after room or equipment changes.
- Control listening exposure
- Maximum output and limiters do not define a safe workday. Calibrate a conservative reference, manage level and duration and follow applicable hearing-health and workplace guidance.
- State the commissioning limit
- Commissioning can document placement, function and a measured baseline. It cannot guarantee neutral perception, translation, approval, uptime, hearing safety, electrical safety or mounting safety.
Evidence used
First-party sources behind this guide
- 01LP-6 Second Wave specifications and documentsKali Audio · checked August 18, 2026Open source
- 028330A Smart Active MonitorGenelec · checked August 18, 2026Open source
- 03KH 120 II product and operating informationNeumann · checked August 18, 2026Open source
- 04A Series operating manualADAM Audio · checked August 18, 2026Open source
- 05Trio6 ST6 product and support informationFocal · checked August 18, 2026Open source
- 06Noise and hearing riskNational Institute for Occupational Safety and Health · checked August 18, 2026Open source
- 07Loudspeaker and room measurement literatureAudio Engineering Society · checked August 18, 2026Open source