Market guide
Commission the complete safe bench
Verify voltage, ESD, extraction and test workCommission the exact station, handpieces, stands, consumables, extraction and ESD path on representative scrap before valuable assemblies enter the bench.
01
Electrical
Verify supply and grounding
Confirm exact voltage, total connected-tool power, protective earth, ESD ground and outlet capacity.
- ESD
- Measure the complete wrist, mat, tool, holder and ground path under the site's program.
- Access
- Keep hot tools stable, identified and away from cords and combustibles.
02
Exposure
Control heat, fumes and residues
Use the alloy, flux and cleaning controls required by the safety data and work process.
- Extraction
- Capture fumes near the source without disturbing hot-air profiles.
- Hygiene
- Lead and flux handling need deliberate handwashing, storage and food-separation practices.
03
Proof
Run representative joints and rework
Inspect wetting, dwell, pad condition, component temperature, residue and repeatability, then set process windows.
- Maintenance
- Document tip care, filters, pump cleaning, calibration, firmware and spare parts.
- Outcome
- A commissioned bench cannot replace workmanship standards, inspection or qualified safety judgment.
Evidence used
First-party sources behind this guide
- 01Current soldering and rework equipmentJBC · checked August 18, 2026Open source
- 02Current soldering and rework systemsHakko · checked August 18, 2026Open source
- 03Lead and workplace exposure resourcesOSHA · checked August 18, 2026Open source