Market guide
Commission and maintain an automatic water shutoff system
Test sensing, closure and recovery before relying on itCommission the exact wet sensors, flow or pressure rules, motorized valve, manual control, alarms and notification paths. Retest after plumbing, network, firmware or household-use changes.
01
Test
Run controlled detection drills
Wet each point sensor safely, create documented representative flow where allowed and confirm event, command, valve movement and actual stopped flow.
- Closure
- Observe the physical valve rather than accepting only an app state.
- Blind spots
- Record events and sources that the system cannot detect or close.
02
Recover
Prove outage and manual operation
Test loss of mains power, battery depletion, hub, internet, cloud and phone access plus the exact manual reopen or isolation procedure.
- Safety
- Do not restore water blindly after freeze, contamination, backflow, fire or structural damage.
- Access
- Keep a documented local procedure available to occupants and responders.
03
Maintain
Assign recurring ownership
Exercise the valve, inspect detectors and cables, replace batteries, review learning and thresholds and confirm every notification recipient.
- Subscription
- Record which monitoring, history or insurance features stop when a plan ends.
- Service
- Track firmware, support, parts, account transfer and a safe replacement or bypass plan.
Evidence used
First-party sources behind this guide
- 01Leaks and water useU.S. EPA WaterSense · checked August 18, 2026Open source
- 02Flo Smart Water Monitor and ShutoffMoen · checked August 18, 2026Open source
- 03Current smart-water systemsPhyn · checked August 18, 2026Open source